Trouble Shooting - LEMAN PON250 Manual De Instrucciones

TROUBLE SHOOTING

Warning:
For your own safety, remove the plug from power source outlet before troubleshooting your sander!
TROUBLE
Sander does not operate.
Motor slows when sanding.
Wood burns while sanding.
Sander makes excessive noise.
PROBALE CAUSE
Not plugged into power outlet.
Power switch defective.
Motor or wiring problem.
Timing belt too tight.
Applying too much pressure
workpiece.
Sanding disc or belt is loaded with
debris.
Timing belt too tight.
Bearing need oil.
19
EN
REMEDY
Plug into power outlet.
Replace switch.
Have qualified electrician carry out
repair.
Decrease tension.
on Apply less pressure to workpiece when
sanding.
Clean or replace disc or belt.
Decrease tension.
Oil bearing.