Holzmann FS 160L Manual De Instrucciones página 7

Forcing your machine shortens it`s lifespan, may cause machine
defects and poses a security risk.
DO NOT OVERREACH
Keep proper footing and balance at all times.
SECURE SMALL WORKPIECES
When processing small workpieces, fix them with a suitable de-
vice like a vice, downholder, to avoid accidents.
Do not fix or feed small workpieces by hand.
Keep your hands away from dangerous area, allways guide the
workpiece or tool securely.
MAINTAIN TOOLS WITH CARE
Assure yourself to keep your working tools always sharp and in
best working condition.
Defect or blunt tools pose a security risk.
MAINTAIN SAFETY GUARDS, COMPONENTS AND SIGNS
Assure yourself, that all safety guards and safety devices of your
machine are working in best condition. Damaged Safety guards
have to be repaired before using the machine again.
Check the function of the machines Safety components like
Emergency OFF Buttons and Disconnectors in regular intervals.
Defect Safety components have to be replaced immediately.
Check the condition of the Safety signs and operation rule plates
on your machine. Replace missing or non-readable ones.
NEVER LEAVE MACHINE RUNNING UNATTENDED
Before leaving the machine, shut it off and wait until the motor
and all rotating parts stop.
REMOVE UNUSED TOOLS, KEYS, WRENCHES
Form a habit to check that there are no tools, keys, wrenches ...
on the machine/tool before you start the machine.
Remove all accessories and tools from the machine before you
switch it on.
SPECIFIC SPINDLE SHAPER SAFETY RULES
When installing a new cutter, keep the unused segment of
the cutter below the table.
Adjust the guides as near as possible to the cutter
After installing a new cutter, always rotate the spindle - with the
machine being unplugged - by hand in order to check that the
cutter runs freely and does not touch any machine part.
Always ensure that the cutter, the fence, the spindle height and
tilt and all other adjustable components are fixed and tightened
properly before operation.
Do not forget to unblock the spindle after installing a new
cutter.
Use only cutters that are certified and comply with the