Kohler K-874-H Manual De Instrucciones página 10

Press the "Jets"
button to turn on and
off the whirlpool
functions
12. Confirm Proper Operation
Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
- Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully counterclockwise.
- Fill the whirlpool to a water level at least 2" (5cm) above the top of the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104_F (40_C).
Operating Sequence
NOTE: A built in heater automatically maintains the water temperature when the whirlpool is running.
- Press the Jets" button to turn on the whirlpool at high speed.
- Adjust each jet for optimum air/water mixture. Turn the trim ring clockwise to reduce the air flow, and
counterclockwise to increase the air flow.
- Press the Jets" button again to run the whirlpool at low speed.
- Press the Jets" button a third time to turn off the whirlpool.
NOTE: A built in timer automatically stops the whirlpool after approximately 20 minutes of operation.
A
1011683-2-
Turn the jet trim
ring clockwise to
decrease the flow
10
Turn the jet trim ring
counterclockwise to
increase the flow
Kohler Co.