Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
WIRELESS CONNECTION
This appliance can be controlled with a wireless
application on your wireless device.
Visit https://www.danby.com/support/apps to
download the application and learn about its
operation.
This dehumidifier can be controlled with a wireless
application on your wireless device. Reference the
wireless manual included in the accessory bag for
more information.
• Press and hold the filter button for 3 seconds to
activate the wireless connection. "AP" will show
on the display when the appliance is in wireless
connection mode.
AP showing on the display
• "AP" stands for "access point" and is used for
the wireless connection feature.
• If "AP" is showing on the control panel display,
this means you have activated the wireless
connection.
• If you are not going to use a wireless
connection, power off the unit.
• AP mode will shut down automatically after 8
minutes.
WATER REMOVAL
There are three ways to remove collected water
from the appliance.
1. Water Bucket
The dehumidifier will automatically collect
condensed water in the water bucket. When the
bucket is full, the compressor and fan will turn off
and the full bucket indicator light will turn on. The
display will show "P2".
To empty the bucket, gently remove it from the
appliance by gripping both sides and pulling
outward. Be cautious when removing the bucket, it
will be full and can be heavy.
Do not place the water bucket directly on the floor.
The bottom of the bucket is uneven and it will fall
over and spill water.
Empty the bucket and replace it in the appliance.
The dehumidifier will not function without the bucket
installed.
Never tamper with or attempt to defeat the water
level float system. Proper installation of the water
bucket is crucial in maintaining reliable operation.
Note: When removing the bucket, the pump arm
for the drain pump may fall down. It must be gently
pushed upward back into the correct position before
replacing the bucket.
12
Publicidad
