Preparation For Use; Power Supply - Nevir NVR-483 UB Manual De Instrucciones

Welcome
Thank you for purchasing the Micro system Player NVR-483UB. In order to fully
benefit from this product, please follow the instructions in this user manual very
carefully. Store this user manual in a safe place for future reference. We are sure
your new Micro system will satisfy your needs.

PREPARATION FOR USE

Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material
from the unit itself.
* Remove any descriptive labels that may be found on either the front or top cabinet
of the unit. Do not remove any labels located on either the back or button cabinet
of the unit.
* Press the CD door OPEN Button to open the CD compartment door. There is a
white card in the CD compartment which is intended to prevent the CD pickup
from moving during shipment of the product.
Remove this card from the CD compartment before use.

POWER SUPPLY

Using AC Power
1. Check if the power voltage, as shown on the type plate located on the bottom of
the set, corresponds to your local AC power supply. If it does not, consult your
dealer or service center.
2. Connect the power cord to the AC socket inlet and the wall outlet, the power
supply is now connected and ready for use.
3. To switch off completely, unplug the power cord from the wall outlet.
4. Unplug the power cord from the wall outlet to protect your set during
heavy thunderstorms.
Batteries (not included)
Open the battery compartment and insert sixbatteries, type LR14, UM-2 or C-cells,
(Preferably Alkaline) with the correct polarity as indicated by the" +"and"-" symbols
inside the compartment
Batteries contain chemical substances, so they should be disposed
of properly.
Incorrect use of batteries can cause electronic leakage and will corrode the
compartment or cause the batteries to burst. Therefore:
Do not mix battery types: e.g. alkaline with carbon Zinc. Only use batteries of the same
type for the set.
When inserting new batteries, do not try to mix old batteries with new ones.
Remove the batteries if the set is not be used for a long time.
EN-1