Clock Adjustment; Radio Function - Nevir NVR-483 UB Manual De Instrucciones

CLOCK ADJUSTMENT

To setup the time of the unit
1. Connect the AC power cord (The following operation must be done in standby mode).
2. Press the REPEAT/TIME/ PROGRAM button to enter into time setting mode. The time
will flash on the LCD display.
3. Press the BACK or NEXT buttons to select the time format 12h or 24h to adjust the time.
4. After setting the time, press the REPEAT/TIME/ PROGRAM button to confirm.
5. Then you can set the hour and the minute with the same method of steps 3-4.
6. After setup the unit time, long press REPEAT/TIME/ PROGRAM button to set the time
to working automatically, with the same method of steps 3-4.

RADIO FUNCTION

Radio reception
1. Press FUNCTION button select RADIO mode.
2. Tune to required station by press BACK/TUNE DN or NEXT/ TUNE UP
Manual Tuning: Rotate BACK or NEXT and then release within 1 sec.
Auto Tuning: Press the play/pause button enter the automatic channel
scan mode, and to be put automatically sets.
Preset Channel:(FM 30 Preset memories)
(1) Press BACK or NEXT Select desired station.
(2) Press play/pause button once , the MEMORY number indicator begins steady
in the display.
(3) Push play/pause button repeatedly to select the desired number.
(4) Press PROGRAM button to save that station.
(5) Repeat steps (1) to (4) procedures for other stations.
3. After storing the stations, press TU+ to play the selected frequency.
4. Press [VOL-] or [VOL +] to adjust the volume level.
5. Extend the telescopic antenna to its full length while listening in FM mode and for
better reception.
6. Turn off the radio by pressing the FUNCTION button. Select any other mode or press
the power button to off the unit.
7. The preset memories will be stored even though the unit is switched off and on.
EN-4
.