Maclean Energy MCE504 Manual De Instrucciones página 8

indicator on the device stops flashing and turns into being long lit, then it
means that the addition is complete.
B:If there showed connect failed on the screen of phone，then need change to
slowly flash state.
① On the faster flash state, press SET button for 5 seconds, the WIFI indicator
on the LCD screen will be lit and enter the slowly flash state;
② open the phone, connect the WIFI named "Smartlife" (without passpord).
③ Open the "Smart life" software on the mobile phone to connect the device.
④ When the phone interface shows the addition is successful, and the WIFI
indicator on the device stops flashing and turns into being long lit, then it
means that the addition is complete.
10. Mobile phone remote operation (connect device power and turn on the side
switch, so that the device is in standby mode)
⑴ Temperature setting:
① Open the "tuya smart" software to select device (when using one mobile
phone to control more than two devices, you need to select the device to be
operated);
② Click the device to be operated and enter the device operation interface,
then the power button on lower left corner of the mobile phone interface will
display OFF and the phone interface color is dark red, indicating that the
device is turned off.
③ Click on the switch and power button on the lower left of the phone interface
will display ON and the phone interface color is bright red, indicating that the
device enters power-on state;
④ Press "+" or "-" button to set the temperature; when the set temperature is
25 ℃ , the ECO indicator will be lit;
⑤ When the setting temperature is higher than the ambient temperature, the
device begins to heat; otherwise the device is in the to-be-heated state.
⑵ Power-on reservation:
① Open the "tuya smart" software to select the operating device;
② Click the device to be operated and enter the device operation interface,
while the power button on lower left corner of the mobile phone interface will
display OFF and the device is turned off;
③ Click on timing, timing into the interface, click on add timing, choose the
time clock, minutes, weekly status, adjust the switch state to open, click ok
button to return to add timing interface, click on the temperature, the
temperature set into the interface, set the boot temperature (the temperature is
expected to achieve the temperature of the room, generally choose the highest
℃
setting temperature of 37 ), click ok to return to add timing operation
interface, click the "save" to save Settings interface right corner to return to the
interface of timing, "please" to return to the top left hand corner click on timing
interface equipment operation interface, timing boot set to complete the
booking.
⑶ Shutdown reservation:
① Open the "tuya smart" software to select the operating device;