Maclean Energy MCE504 Manual De Instrucciones página 9

② Click the device to be operated and enter the device operation interface;
③ Click the power button which will display ON and enter the power-on state;
④Click on timing, timing in to the interface, click on add timing, choose the
time clock, minutes, weekly status, adjust the switch state to close, click ok
button to return to add timing interface, click the "save" to save Settings
interface right corner to return to the interface of timing, "please" to return to
the top left hand corner click on timing interface equipment operation interface,
timing boot set to complete the booking.
⑷ Child Lock:
① Open the "tuya smart" software to select the operating device;
② Click the device to be operated to enter the device operation interface;
③ Complete the timer setting or temperature setting, and click the child lock
button to display the child lock latch icon and ON, indicating that the child lock
button latch is completed;
④ To re-adjust the settings, the mobile phone interface can be set directly
without operation unlock, but if you manually operate the device settings, you
must first press the device's child lock button for 3 seconds or click the child
lock button on the operation interface. When the operation interface displays
the unlock icon and OFF, it means that the unlock is successful and you can
reset the device.
11. Device sharing:
① Open the "tuya smart" software and enter the "Personal Center" to click
Device Sharing;
② Click "Add Sharing" to enter a new member's phone number or click phone
contacts to select new member's phone number. Then click OK to complete
the addition.
12. Cancellation of device sharing:
① Open the "tuya smart" software and enter the "Personal Center" to click
Device Sharing;
② Delete the phone numbers of shared members to cancel the device sharing.
13. WIFI address replacement:
⑴ Remove the device on mobile phone:
① Open the "tuya smart" software to enter my device;
② Click the device that needs to replace WIFI address to enter the device
operation interface;
③ Click the "..." on top right of the operation interface;
④ Click Remove Device and click OK to remove the device;
⑤ Manually remove device: Press SET button for 5 seconds to remove the
device directly;
⑵ Add Device:
① Place the device into a new wireless LAN environment;
② Turn on the switch on the side of the product, and the OF indicator on the
LCD screen will be lit, while the device enters standby mode;
③ Press the power button and the "ON" indicator on the LCD screen will be lit,
and the device enters power-on state;