Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION FOR USE
Information on the use of printed and light-cured models made from VarseoWax Model
1. Models can be insulated (Isocera) to prevent the wax from adhering.
2. Models can be duplicated with silicone (e.g., Wirosil
WiroGel).
3. It is possible to produce deep drawing copings (Adapta) on stump models.
4. It is possible to produce deep drawing splints on models with all teeth as a one-off
application.
Note: Avoid overheating the foil when deep drawing plastic foils!
5. Can be repaired or expanded by partially applying original material in a droplet shape.
Note: In case of extensive imperfections, cracks or fractures, refabrication is advisable.
8. Cleaning in the dental laboratory
Fully cured models made from VarseoWax Model can be easily cleaned by means of steam
cleaning (Triton) or under running water.
Note: Scalding with boiling water (100 °C) is contraindicated as it can deform the models!
9. Disposal
The cured, separated material (base plate, support structure) can no longer be used. Cured
material can be disposed of as domestic waste. Unused resin or ethanol used for cleaning
with resin residues must be disposed of via the local waste disposal authority or a hazardous
waste collection point stating the safety data sheet.
10. Material properties and scope of delivery
Physical data
Colour
Density
Viscosity
Flexural strength
Delivery form
VarseoWax Model
yellow-brown
approx. 1.12 g/cm
3
1,100 mPa*s
≥ 50 MPa
Contents
Presentation
1 kg
bottle
) or duplicating gel (e.g., Castogel;
plus
Flexural modulus
Layer thickness
Charpy impact strength
Wavelength
Qty
1
EN
≥ 1.500 MPa
50 µm
≥ 3 kJ/m²
405 nm
REF
41010
Publicidad
