Repair; Alerts; Time Out During Water Filling; Time Out During Drink Production - Fiamma QUADRANT Manual De Instrucciones

ENGLISH

7. Repair

All repair works must be carried out by suitably qualified and competent persons.
 In order to access the machine's interior, take off the side panels, the lower tray or the upper tray,
depending on what part of the machine's interior you want to reach.
 Only use authentic spare parts.
In order to take off the side panels, unscrew the screw on the upper part of the panels and unfasten the
springs.
In order to access the pressostat, the safety thermostat and the heating elements, take off the RIGHT
side panel.
In order to access the electric components, the manometers, the level probes, the motor and the pump,
take off the LEFT side panel.
In order to access the water entry block, the main switch and the flowmeter (volumetric counter), take
off the lower tray. The lower tray is not fixed to the body of the machine, thus being easy to take out.
In order to access the groups, the electric unit, the keyboards and switches, take off the upper tray. The
upper tray is fixed to the machine with a screw in the middle of the tray.

8. Alerts

8.1.

Time out during water filling

CV MODELLS
When the water level sensor in the boiler doesn't detect water, the machine automatically restarts the
water filling. The counter controls the duration of the water filling. If the filling takes longer than the
preprogrammed time (TIME OUT), the machine automatically interrupts the filling. All LEDs on the
keyboard blink as alert. In order to deactivate this alert, switch off the machine and switch it on again.
SEMI-AUTOMATIC MODELS
During the water filling, the red signal light is blinking until the maximum water level has been reached.
In case the maximum level has not been reached within 180 seconds, the water filling is automatically
interrupted and the red signal light turns on (without blinking). In case this error recurs, check the water
level probes and the water entry block for problems.
8.2.

Time out during drink production

When the machine produces a drink with a pre-programmed portion (keys 1-4), a volumetric counter
measures the water volume used for the drink production with electronic impulses. If the counter does
not receive any impulse for more than 5 seconds, the LED on the key that corresponds with the selected
drink starts to blink (but the production continues). If the counter still does not receive any impulse for
more than 1 minute, the drink production is automatically stopped..
26
Quadrant Espresso Coffee Machines by fiamma - Operating Manual