Cleaning; Daily Cleaning - Fiamma QUADRANT Manual De Instrucciones

ENGLISH
In order to extract steam, turn the steam control knob (1) positioned above the steam wand (3) to the
right. Steam streams out of the wand. Turn the steam knob to the left to close the steam wand.
 Before using the steam wand, open it for 1 or 2 seconds in order to clean off any discharges.
 Clean the steam wand with a wet cloth after each usage.

6. Cleaning

Do not use jets of water to clean the espresso machine. Do not pour water onto the machine or
onto any of its attached components.
Before cleaning, let the machine cool down!
In areas which may be subject to infestation by cockroaches or other vermin, pay particular
attention to keeping the machine and its surroundings clean at all times. Any damage caused by
cockroaches or other vermin will not be covered by the guarantee.
6.1.

Daily Cleaning

CLEANING OF THE GROUPS
AUTOMATIC MODELS (CV MODELS)
These models feature an automatic cleaning
program.
1. Put the blind filter supplied with the
machine into a portafilter.
2. Insert the portafilter into the group that you
want to clean.
3. Simultaneously, press key 1 and 5 in order to
start the cleaning.
4. During the cleaning, the LEDs of both keys
blink.
5. When the cleaning is over, the Leds stop to
blink. The machine automatically returns
into normal functioning mode.
6. Take out the portafilter.
 Let the group run 2-3 times in order to rinse it.
 You can run the cleaning program on several
groups at the same time.
CLEANING OF FILTERS AND PORTAFILTERS
Add some detergent for coffee machines to hot water and bathe the filters and portafilters in the water.
CLEANING OF THE MACHINE
Disconnect the machine from the electric mains supply before performing any kind of cleaning!
Let the machine cool down before performing any kind of cleaning!
Clean the screw driver of the portafilter and the groups with a humid cloth.
Carefully clean the water taps and the steam wands in order to avoid the building up of crust.
24
Quadrant Espresso Coffee Machines by fiamma - Operating Manual
SEMI-AUTOMATIC MODELS
1. Put the blind filter supplied with the
machine into a portafilter.
2. Insert the portafilter into the group that
you want to clean.
3. Press the switch button above the group
you want to clean in order to activate the
group.
4. Press the switch button above the group
in order to stop the group.
5. Repeat this operation until the water that
comes out of the group is clear and shows
no signs of detergent.
6. Take out the blind filter and put a normal
filter into the portafilter. Insert the
portafilter into the group.