BaByliss PRO FX ONE FX799 Manual De Instrucciones página 4

OPERATING INSTRUCTIONS
ON/OFF SWITCH
To operate trimmer, simply slide switch to the ON ("I") position. To stop operation,
slide switch to the OFF ("0") position. Make sure the switch is in the OFF ("0")
position when the trimmer is not being used.
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void
the warranty.
REPLACING (REMOVING) BLADE SET
To remove the blade set, turn the trimmer to the OFF ("0")
position. Turn the trimmer upside down so that the teeth
of the trimmer are facing down. Place the trimmer on a
flat surface and using the included screwdriver, loosen the
fastening screws from the blade set. Remove the blade
set from the trimmer (see Fig. 1).
To install or replace your trimmer blade set, reverse the procedure, aligning the
blade cushion shaft into the moving blade cushion (see Fig. 2). With the blade held
in place, replace blade screws and loosely tighten. Turn the trimmer over and align
the blade set parallel to the trimmer's upper housing.
Fig. 2
Screws
Moving blade
Fixed blade
Screws
FX799 IB-18194.indd 7-8 FX799 IB-18194.indd 7-8
Blade set
Blade screws
Blade cushion
Screw holes
BLADE CARE
Because the trimmer blades are precision-made for a very special use, they should
always be handled with care and cleaned and oiled regularly to ensure maximum
performance. Each time you finish using the trimmer, take the cleaning brush
provided and brush away any loose hair that has collected in the blades. To oil,
apply a few drops of oil to the blades and wipe off any excess oil with a dry cloth.
Wipe the housing clean with a dry cloth.
Any other servicing should be performed by an authorized service representative,
since the appliance has no other user-serviceable parts. This product is for
commercial use.
Fig. 1
DO NOT RINSE BLADE, TRIMMER, BATTERY, OR CHARGER
ZERO-GAP ADJUSTMENT TOOL
IMPORTANT! Only attempt to zero gap the blades by using the adjustment tool and
following these instructions very precisely. The adjustment tool is required to adjust
the blades to zero gap, which will achieve a closer, more precise cut.
Step 1 – Using the screwdriver included, gently loosen
the two small screws on each side of the blade.
Step 2 – Slide the zero-gap tool over the fixed blade
until it is tight against the back portion of the moving
cutting blade.
2023/8/30 10:03 2023/8/30 10:03