AVS 20183 Instrucciones De Instalación página 2

Installation Steps
Use an alcohol pad to clean the hood surface
underneath the OUTBOARD rubber trim pieces.
3
Separate each fastener assemby into two pieces.
5
Press (4) sleeves into the holes. If necessary use tape to hold them firmly in place.
7
Reposition the hood shield with the tabs sliding between the hood and rubber seal and align with holes.
8
NOTE: Actual application may vary slightly from illustrations.
sleeve
fastener
Remove red tape liners from both OUTBOARD tabs of hood
4
Carefully lift the weatherstrip away from the hood surface at the
same (4) locations to expose holes in hood.
6
Page 2 of 3
shield.
NOTE: Use caution not to
damage weatherstrip.