Publicidad
Idiomas disponibles
Idiomas disponibles
FILLING THE WATER TANK
Please note the following when filling the water tank:
• Pull out the water tank on the front of the air cooler.
• Carefully fill the water tank with clean water using a
watering can or similar container. Pay attention to the
level on the front of the water tank:
MIN mark: The water tank must be
MIN mark for the pump to work properly.
MAX mark: The water tank must not be filled above the
MAX mark, as otherwise water could get inside the
appliance and damage electronic parts.
• Make sure that the outside of the unit is not damp or
wet and wipe it down if necessary.
• Then push the water tank back into the machine.
PREPARE REMOTE CONTROL - INSERT OR REPLACE BATTERIES
Please follow the instructions below:
Initial operation:
To operate the remote control for the first time, please pull out the plastic
protector from the battery compartment on the back of the remote control.
Change battery:
•
Pull out the battery holder on the back of the remote control and
remove the old battery from the holder
• Now insert a new CR2025 battery, always paying attention to the polarity
markings (+/-) on the battery and the battery holder.
• Then push the battery holder fully back into the remote control.
filled above the
REMOTE CONTROL
177
:
Publicidad
