System Sensor WSF-RF Serie Instrucciones De Instalación página 3

Sounder Strobe Status
Status Sound
Power on initialisation Double chirp
(no fault)
Single chirp
EU Declaration of Conformity
Hereby, Honeywell Products and Solutions Sàrl declares
equipment type WSF-RR-RF / WSF-WR-RF
The full text of the EU DoC is available at the following internet address:
https://www.systemsensoreurope.com/products/category/wireless-fire-systems/
No.
1
2
3
4
5
6
7
8 (3)
9
10
11
12
13 (1)
14 (1)
15 (1)
16 (1)
17 (1)
18 (1)
19
(1)
20
21
(1)
22
23
24 (1)
25
26
27
28
29
30
31
32
33 (2)
34
35
36 (1,2)
37 (1,2)
38 (1,2)
Notes:
(1) Tones not affected by intermittent user pattern
(2) Only available through Advanced Protocol commands
(3) Default tone; (Default volume = HIGH)
D200-311-00
Honeywell Building Technologies, Building 5 Carlton Park, King Edward Avenue, Narborough, Leicester LE19 3EQ
Meaning
Device is un-commissioned
(factory default)
Device is commissioned
that the radio
is in compliance with directive
2014/53/EU
Pattern Nominal
Frequency (Hz)
Alternating 554/440
Alternating 800/970
Alternating 800/970
Alternating 2400/2900
Alternating 2500/3100
Alternating 988/645
Continuous 660
Continuous 970
Continuous 1200
Continuous 2850
Sweep 150‐1000
Intermittent 660
Sweep 500 ‐ 1200
Intermittent 660
Intermittent 970
Intermittent 970
Intermittent 2850
Intermittent 970
Intermittent 950
Continuous 800
Sweep 400‐1200
Sweep 1200 ‐ 500
Sweep 2400 ‐ 2850
Sweep 500 ‐ 1200
Sweep 800 ‐ 970
Sweep 800 ‐ 970
Sweep 800 ‐ 970
Sweep 2400 – 2850
Sweep 500 – 1000
Sweep 500 – 1200 – 500
Sweep 800 – 1000
Sweep 2400 ‐ 2850
Continuous 4000
Continuous 440
Continuous 554
Intermittent 660
Intermittent 660
Intermittent 2850
RF mesh network is created by the gateway. (For further information, see
the Radio Programming and Commissioning Manual - ref. D200-306-00.)
NOTE: Do not try to commission more than one gateway system at a
time in an area.
TESTING
Regular testing of fire alarm equipment is important to ensure its continued
correct operation. This device is designed to have a battery life of at least
4 years. The battery lifetime includes provision for periodical testing of the
sounder-strobe, providing this does not last for more than 30 seconds per
week.
Table 1: Sounder Tones
Switching Cycle
2Hz (0.1s/0.4s)
Rising from 150Hz to 1000Hz (10s), 40s
@ 1000 Hz, falling from 1000Hz to 150Hz
(10s), 20s @ 150Hz (Total 80s)
0.5Hz 6.5s on, 13s off
0.25s off, 3.75s on
3.33Hz 0.15s on, 0.15s off
0.8Hz 0.25s on, 1s off
0.5Hz 1s on, 1s off
1Hz (0.5s on, 0.5s off)
0.22Hz (0.5s on, 0.5s off) rpt x3, 1.5s off
(0.5s on, 0.5s off) rpt x3, 1.5s off
0.99Hz 1s on, 0.01s off
(0.5s off, 3.5s on)
0.166Hz rise 1s, stable 4s, fall 1s
0.05Hz 6.5s on, 13s off
0.277Hz 1.8s on, 1.8s off
4Hz (0.15s on, 0.1s off)
Sounder output approved to EN 54-3
only at high volume setting. Output
sound pattern data, in accordance with
EN 54-3, is available in Document Ref:
S00-7001-xxx.
2nd Stage
Tone
1Hz
2Hz
3Hz
2Hz
2Hz
1Hz
7Hz
50Hz
7Hz
1Hz
50Hz
7Hz
2Hz
1Hz
7
8
8
10
10
8
1
2
2
4
22
7
12
7
8
8
10
8
12
22
12
20
10
8
8
8
8
10
8
8
8
10
5
35
34
7
7
10
Patents Pending
I56-6661-001