Publicidad
Idiomas disponibles
Idiomas disponibles
Operations & Parts Manual
Air Grease Gun
Maintenance
Lubrication
An automatic in-line filter-regulator-lubricator is recommended
as it increases tool life and keeps the tool in sustained
operation. The in-line lubricator should be regularly checked
and filled with air tool oil. Proper adjustment of the in-line
lubricator is performed by placing a sheet of paper next to the
exhaust ports and holding the throttle open approximately 30
seconds. The lubricator is properly set when a light stain of oil
collects on the paper. Excessive amounts of oil should be
avoided.
In the event that it becomes necessary to store the tool for an
extended period of time (overnight, weekend, etc.), it should
receive a generous amount of lubrication at that time. The tool
should be run for approximately 30 seconds to ensure oil has
been evenly distributed throughout the tool. The tool should be
stored in a clean and dry environment.
Always disconnect from the air source hose before
attempting any maintenance.
1.
Always make sure the dispensing nozzle of the grease
gun is clean before using.
Pump a small amount of grease out of the dispensing
nozzle, then wipe off with a clean rag or lint-free cloth
before attaching to the grease fitting.
Make sure the nozzle and the tip of the Grease Gun are
clear of dirt, grease, or any debris.
2.
Clean the grease fitting of all dirt before attaching the
grease gun. Inspect and replace damaged fittings. Also
clean the grease fitting after applying grease. It is helpful to
use grease-fitting caps to keep them clean, but still wipe
fittings clean before applying grease.
3.
After each use, clean leftover grease from the Tube.
4.
Wipe down the unit with a lint free cloth.
Recommended lubricants: Use Husky air tool oil or any other
high grade turbine oil containing moisture absorbents, rust
inhibitors, metal wetting agents and an EP (extreme pressure)
additive.
Model No. CAT820
5
Publicidad
