Tineco FLOOR ONE S5 Serie Manual De Uso página 28

Brush Roller
1.Remove the brush roller by grabbing the brush
roller tab and pulling out.
Fig.D-11
2.Use the cleaning tool to remove the hair and
debris wrapped around the roller and then
rinse the roller with water. Replace the brush
roller back into the accessory holder, and allow
it to dry completely before reinstalling.
Fig.D-12
3.Remove hair and debris from the brush roller
chamber and the opening with a tissue or a
damp cloth.
Fig.D-13
4.Replace the brush roller by inserting the brush
roller end into the right side of the holder, then
attach the roller tab to the magnetic buckle on
the left side to lock into place.
Fig.D-14
Brush Roller Replacement
5.Pull up the roller handle to remove it. Once
removed, install the handle into the new brush
roller. When uninstalling, do not directly pull on
the pull ring of the brush roller.
Fig.D-15
Note:
• A spare brush roller is provided with your
appliance for convenient replacement.
• To maintain optimal performance, replace the
brush roller every 6 months.
SCAN THE QR CODE BELOW TO
GET PRODUCT CARE VIDEOS.
TROUBLESHOOTING
Problem
The appliance does
not turn on
Weak suction
Brush roller tangled
indicator blinking
Voice prompt:
Please clean the brush
roller
CWT empty indicator
blinking
Voice prompt:
Clean Water Tank
empty, please refill
water and cleaning
solution
DWT full indicator
blinking
Voice prompt:
Please clean Dirty
Water Tank
All lights off in
operation
Battery level indicator
blinking
Voice prompt:
Low battery, please
charge
Self-cleaning icon
blinking
Note:
If the above troubleshooting guide fails to
provide a solution, please visit our website
www.tineco.com for further support.
26
Solution
Restart after cooling
down
Install the dry filter or
clean and allow it to
dry completely
Remove blockages
Refill CWT
Empty the dirty water
and then reinstall the
DWT
Cool the appliance
down and restart
Charge the appliance,
or restart
Start self-cleaning