Tineco FLOOR ONE S3 Serie Manual De Uso página 26

Indicator
When in Use
Battery level ≥ 10%: battery
indicator will be illuminated.
Battery level < 10%: battery
indicator will be blinking.
Off: no power detected or
possible battery malfunction.
Blinking red: dirt sensor
malfunction or blocked.
Indicator blinking: CWT is
empty.
Indicator blinking: DWT is full
or channel has a blockage.
Indicator blinking: brush roller
has a blockage.
Indicator blinking: appliance is
in need of self-cleaning.
During Charging
Tineco indicator: blinking.
Fully Charged
In 5 minutes: Tineco indicator
illuminated.
After 5 minutes: all indicator
lights turn off.
Voice Prompt
please in kind prevail.)
Status
Battery level: 10~20% Low battery
Battery level: 0~10%
Clean Water Tank is
empty
Dirty Water Tank full
or channel blocked
Dirty Water Tank
is full during self
cleaning
Dirty sensor
Dirty dry filter
Brush roller is
tangled
Too much wear of
brush roller
Shutting down (takes
3s to shut down)
Power is off
Start charging
Need self cleaning
Appliance not on the
charging dock
Battery insufficient
for self-cleaning
Sufficient battery to
start self cleaning
Cleaning brush roller Cleaning brush roller
Cleaning debris
channel
Auto detecting
24
(Contents may vary,
Reminder
Low battery, please
charge
Clean Water Tank empty,
please refill water and
cleaning solution
Clean the Dirty Water
Tank or the debris
channel
Dirty Water Tank full,
please empty
Please begin self-
cleaning cycle
Please clean the filter in
Dirty Water Tank
Please clean the brush
roller
Please replace the brush
roller
Shutting down
Power off
Charging has
commenced. Auto-
detecting whether to run
self-cleaning cycle
Please begin self-
cleaning cycle
Please place appliance
on the charging dock
Low battery, start
charging
Start self cleaning
Cleaning debris channel
Auto detecting