Digital Projection M-Vision 930 3D Serie Información Importante página 5

Digital Projection
M-Vision 930 3D Series
Installation precautions
The projector must be installed only by suitably qualified personnel, in accordance with
local building codes.
The projector should be installed as close to the power outlet as possible.
The power connection should be easily accessible, so that it can be disconnected in an
emergency.
Ensure that there is at least 30 cm (12in) of space between the ventilation outlets and
any wall, and 10 cm (4in) on all other sides.
Do not install the projector close to anything that might be affected by its operational
heat, for instance, polystyrene ceiling tiles, curtains etc.
The projector is heavy. Use safe handling techniques when lifting the projector.
When stacking projectors, the stack MUST be vertical, to ensure that the stresses are
distributed to all four chassis corners.
Before installation, make sure that the surface, ceiling or rigging that is to support the
projector is capable of supporting the combined weight of the projector and lens.
Backup safety chains or wires should always be used with ceiling mount installations.
Do not place heavy objects on top of the projector chassis. Only the chassis corners
are capable of withstanding the weight of another projector.
Do not stack more than 3 projectors.
Do not drop or knock the projector.
Place the projector in a dry area away from sources of dust, moisture, steam, smoke,
sunlight or heat.
Do not tilt the projector more than ±12° from side to side when in use, as this may
cause serious lamp failure, damage the lamp module and cause extra cost on
replacement.
The projector may be tilted forwards and backwards as necessary.
Rev C August 2014
±12°
360°
Important Information
Page 5