Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Troubleshooting
Problem
no symbols light up.
Machine brews but no
O
Automatic mode
remains in stand-by
mode.
O
Automatic mode
goes straight to
N
Manual mode.
More Customer Service information is available online at www.tassimo.com
TAS45 USA 090724.indd 15
Downloaded from
www.Manualslib.com
The following table provides solutions for problems and
glitches that may arise as you use your TASSIMO machine.
problem persists after troubleshooting please contact TASSIMO
Customer Service at 1-877-TDISCS1 (1-877-834-7271).
!
Note: If piercing unit is missing,
it may be purchased from TASSIMO
or Bosch Customer Service Department
at 1-877-TDISCS1 or only in the USA on www.tassimo.com.
Possible cause
There is no power supply.
during the brewing process or
there is air in the system.
No T DISC inserted.
The barcode could not be
detected.
The barcode could not be
detected.
manuals search engine
Solution
properly plugged into the
power supply.
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
inserted.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact
TASSIMO Customer Service
Department at 1-877-
TDISCS1.
Clean the bar code reading
window.
Use another T DISC.
by holding down the start /stop
button.
24.07.2009 11:23:05
15
7/2009
Publicidad
