Publicidad
Idiomas disponibles
Idiomas disponibles
Product Dimensions
D
A
B
C
E
F
N
A. 1.09 m (43")
B. 970 mm (38
1
⁄
")
8
C. 890 mm (35")
D. 38 mm (1
1
⁄
")
2
E. 705 mm (27
3
⁄
")
4
F. 650 mm (25
1
⁄
")
2
G. Water inlets
H. 180 mm (7")
Drain System
Standpipe Drain System
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
than 64 L (17 gal.) per minute.
The top of the standpipe must be at least 990 mm (39") high
and no higher than 1.83 m (72") from the bottom of the washer.
H
I
K
Cold
Hot
G
M
L
I.
Power supply cord
J. Drain hose connector
K. Label
L. 685 mm (27")
M. 133 mm (5
1
⁄
")
4
N. 25 mm (1")
O. Water level switch and shaft
P. 127 mm (5")
Electrical Requirements
I A 220-240 volt, 50 Hz., AC only, 10-amp, fused electric
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
serving only this appliance be provided.
I This washer is equipped with a power supply cord having
an earthing plug. The plug should be accessible for
disconnection from the supply.
I If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard.
Using the universal cord included with this washer:
This washer is equipped with a universal cord with
interchangeable mains plugs.
1. Select the appropriate mains plug assembly from those
supplied and attach it to the mains cord connector.
2. Snap the 2 halves of the cord lock together over the
connector to retain it in position.
. . . . . . . .
5
Publicidad
