Publicidad
Idiomas disponibles
Idiomas disponibles
Position the connecting plates (round part).
2168
2366
0341
INSTALL THE GROUND SHEET OR GEOTEXTILE FILM (note: the ground sheet is not included in all kits)
It is important to backfill 8 to 10 cm (mound of fine sand) all around the base of the inside
of the pool and, particularly, along the sides of the pool, and to cover the entire surface
of the pool with a 2 cm layer of sand. The sand prevents the liner from sliding under the
metal sheet and protects it from the protruding parts of the pool structure that could
perforate it (the pressure plates and strap bolts must be totally covered).
Cover the prepared ground with a geotextile film that goes 10 to 12 cm up the wall. Stick
the film to the wall in various places using double-sided adhesive tape. The geotextile film
prevents algae from spreading under the liner.
Approximate amount of sand needed:
POOL WALL CUT OUTS (according to the model)
After assembling the pool wall, make the skimmer and discharge nozzle cut outs using metal cutters or sharp pliers. File the edges
of the cut outs and apply rustproofing agent. We advise wearing gloves during this process.
NOTE: For kits containing two half-walls, each one with cut outs, perform the cut outs on just one of the half-walls and
stick a protective strip (duct tape) on the unused cut outs on the inside of the pool in order to protect the liner.
OSMOSE White Oval
Steel sides
6.10 x 3.65
dimensions
Sand
0.42 m
0341
2464
2268
7.30 x 3.65
3
3
0.51 m
96
0341
2268
Sides
Sand
9.15 x 4.55
3
0.80 m
Assembly Guide 880118-rev F
10 cm
2 cm
Publicidad
