FILLING
1.
Open the lid.
2.
Fill with at least 1 cup of water, but not above max.
3.
Close the lid, and press down to lock it.
USING YOUR KETTLE
1.
Put the stand on a stable, level surface.
2.
Plug the stand into the wall socket.
3.
Put the kettle on the stand.
4.
Move the switch to I.
5.
The light will come on. The kettle will start to heat.
6.
When the water boils the kettle will switch off.
To switch off manually, move the switch to O, or simply lift the kettle off the stand.
7.
GENERAL
Note: When you lift your kettle, you may see moisture on the stand. This is normal and is caused by the
steam used to switch your kettle off automatically.
BOIL DRY PROTECTION
If your kettle boils dry, a safety cut-out device will automatically switch it off. If this happens, unplug your
kettle and allow it to cool down until the cut-out resets itself. Allowing your kettle to boil dry will shorten
the life of the element.
CARE AND MAINTENANCE
1.
Unplug the stand, and let the kettle cool before cleaning.
2.
Wipe all surfaces with a clean damp cloth.
3.
Remove the lid.
4.
Push the hook on top of the filter down then lift the filter out of the kettle (fig A).
5.
Rinse the filter under a running tap while brushing with a soft brush.
6.
Lower the filter into the kettle, and engage the bottom hook in the bottom of the spout.
7.
Press the top of the filter towards the kettle, to lock the hook in place.
8.
Refit the lid.
Descale regularly, (at least monthly).
Use a proprietary descaler. Follow the instructions accompanying the descaler.
Products returned under guarantee with faults due to scale will be subject to a repair charge.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
4