Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Figure 6
Emitter
Transducer
Wire Slot
8.
Install the media on top, media
tray and media (if applicable),
so that the opening is not
blocked (Figure 7).
CAUTION: Do not arrange the
media while the unit is running,
since the media and/or tray may be
hot.
9.
Make sure the On/Off switch
is switched to Off (refer to
Operating Instruction section).
10. Plug the unit into a 15 Amp/
120 volt outlet.
10
Top
Cover
Water Tank
Figure 7
!
NOTE: Rock media shown, install
other medias in the same way.
Retaining
Tab
Fan
Housing
www.dimplex.com
Publicidad
