Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
WARNING ALWAYS UNPLUG THE MACHINE BEFORE ASSEMBLY/INSTALLING ACCESSORIES .
Handle Tube
Tools Needed:
•
(2) 7/16" Wrenches
1 .
Before assembling the handle tube, ensure the handle
clamp is positioned with the hole of the tube facing the
motor . (Fig . 1)
2 .
Slide the handle tube through the handle clamp . (Fig . 1)
3 .
Hold the yoke vertical and insert the tube over the yoke .
(Fig . 1)
4 .
Turn the handle tube so the insert "Lavex" faces the
motor . Align the holes on the tube and the yoke, and
place the two screws in the holes with the heads toward
the wheels . (Fig . 1)
5 .
Place the safety nuts on the screws with the flat part
facing the screw . Tighten by hand, then hold the head
with one 7/16" wrench and tighten the nut with the other
7/16" wrench . (Fig . 1)
6 .
Tighten the adjusting knob clockwise at a desired handle
position until the handle clamp does not slip when tilting
the machine . (Fig . 2)
7 .
Connect the motor cables, making sure the insulating
jacket is over the conductors .
8 .
The power cord support hook can be moved up or down
by loosening and tightening the Allen screws .
Pad Driver or Brush
WARNING DO NOT OPERATE MACHINE WITHOUT BRUSH OR PAD DRIVER AND PAD IN PLACE .
1 .
Unplug machine, secure handle tube in vertical position, and lay down the machine, turning it over its wheels until the underneath
side of the machine is vertical and fully exposed .
NOTE: Place a clean towel on the floor to keep the switch box from scratching .
2 .
Position the three slots of the pad driver/brush over the three lugs of the pad driver .
3 .
Turn the pad driver/brush COUNTERCLOCKWISE as far as it will go .
4 .
To remove the pad driver/brush, disengage the clutch plate slots from the pad driver lugs by turning CLOCKWISE .
NOTE: If you encounter difficulty removing, apply foot pressure to the pad driver/brush until it moves .
5 .
To place a pad, lay it down on the floor first, tilt machine over its wheels so that the machine goes over the pad, center the drive and
pad, then place the machine down over it .
NOTE: The scrubbing pad can be used with the pad driver or with the scrubbing brush .
NOTE: If the pad reduces in size to 1/4" thick, it should be changed . Any thinner and the pad driver could be damaged .
6 .
Your floor machine is now ready to be used .
WWW.LAVEX.COM
Fig . 1
Fig . 2
Loosen
Tighten
User Manual
Handle Tube
Handle Clamp
Screw
Safety Nut
Wheel
Yoke
Adjustment Knob
5
Publicidad
