Publicidad
Idiomas disponibles
Idiomas disponibles
5....-05-HDR 2834
Use
•
The device is intended for private use only.
•
Clean machines, vehicles, buildings, tools, facades, terraces, garden tools etc.
with the high-pressure water jet. If necessary you can also use detergents.
Please use detergents sparingly, noting the quantities recommended by the
producer.
Please note:
•
The cleaning of motors/engines and other surfaces that may be covered with oil
is only allowed in conjunction with an appropriate oil separator.
•
Do not clean any surfaces that may contain hazardous materials, such as asbe-
stos.
Water
•
If necessary, clean the supply water with a water filter. Any impurities in the
water could damage the pump.
•
Operating the high-pressure cleaner without water will damage the pump.
Please ensure before switching on the cleaner that the water supply is availa-
ble.
Bleeding the Device before Use.
•
The device must be connected to the electricity and water supply (See
"Connection", points 1-3 in the section "Operation").
•
Unscrew the high-pressure hose (7) from the high-pressure connection (2) of
the device.
•
Switch on the device and allow it to run until the water coming out of the high-
pressure connection no longer contains any bubbles.
•
Switch off the machine at the main switch (1) and screw the high-pressure hose
(7) back on.
Cleaning Method
1. Spray the detergent sparingly on to the dry surface. Allow it to act for a short
time without letting the detergent dry.
2. Rinse off the loosened dirt with the high-pressure jet.
Water Loss
It is normal for the pump to lose small quantities of water. If there is a sizeable leak,
please contact our service department.
Protection against Damage
Please do not underestimate the pressure produced by the high-pressure cleaner.
If you would like to clean sensitive surfaces it is better to use the fan jet
08.12.2003
9:39 Uhr
Instructions for use
Seite 57
57
GB
Publicidad
