DeWalt DE9107 Manual Del Usuario página 16

E N G L I S H
Do not incinerate the battery pack
60
See technical data for charging time
Package contents
The package contains:
1 Battery charger
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your DE9107 charger accepts D
battery packs ranging from 7.2 to 14.4 V.
Your DE9108 charger accepts D
battery packs ranging from 7.2 to 18 V.
Your DE9116 charger accepts D
NiCd battery packs ranging from 7.2 to 18 V.
1 Charger
2 Charging indicator (red)
3 Battery pack
Electrical safety
Make sure that the voltage of your charger
corresponds to that of your mains.
Your D WALT charger is double
E
insulated in accordance with EN 50144;
therefore no earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 3 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
en - 3
All manuals and user guides at all-guides.com
WALT NiCd
E
WALT NiCd
E
Using an extension cable
WALT NiMH and
E
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see rating plate). The minimum conductor size is
0.5 mm
a cable reel, always unwind the cable completely.
Instructions for use
Charging the battery pack (fig. A)
When charging the battery pack for the first time,
or after prolonged storage, it will only accept an
80% charge. After several charge and discharge
cycles, the battery pack will attain full capacity.
Always check the mains prior to charging the battery
pack. If the mains is functioning but the battery pack
does not charge, take your charger to an authorized
D
and the battery pack may become warm to touch.
This is a normal condition and does not indicate a
problem.
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
2 ; the maximum length is 30 m. When using
Always observe the safety instructions
and applicable regulations.
WALT repair agent. Whilst charging, the charger
E
.
13