Publicidad
Idiomas disponibles
Idiomas disponibles
The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injur/.
The "Green" light indicates that the freezer is properly connected to the electrical power. The
light indicates power supply, and will glow even if the temperature control dial is turned to "0", or
the compressor has failed to work and the compartment is not being cooled.
>
Fast Freeze Mode
The amber light is also a push-button switch, which we call the "fast freeze" switch. When this
button is pressed, the amber light comes on and the compressor runs continuously.
This
function is used to freeze down fresh food which is to be placed in the freezer and must be
switched off as soon as the fresh food is completely frozen (approximately 4 hours) as it uses
more electricity. If left on continuously can damage the unit.
The Amber light indicates that the compressor is on and running. The compressor should not,
under normal conditions, be running continuously unless the unit is in "Fast Freeze" mode.
OPERATING YOUR FREEZER
> Temperature Control
• Your freezer has one control for regulating the temperature. The temperature control is
located on the lower right hand corner.
• The first time you turn the unit on, switch on the Fast Freeze switch (amber light) and run
for at least 4 hours before putting frozen foods inside. This will ensure the cabinet is
thoroughly chilled before food is put in.
• Turn off the Fast Freeze switch.
• The range of the temperature control is from position" 0" the warmest to "5" the coldest.
Adjust the temperature control to the setting that best suits your needs. The setting of "3"
should be correct for home or office freezer use.
• To turn the freezer off, turn the temperature control to "0".
NOTE:
•
Turning the temperature control to "0 11 position stops the cooling cycle but does not shut
off the power to the freezer.
■
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the freezer will not
N start.
" ' Large amounts of food will lower the cooling efficiency of the appliance.
•
If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize between
adjustments.
> The Fast Freeze Switch (Amber)
•
The light glows-while the Fast Freeze switch is in the 'ON' position.
•
The switch overrides the thermostat and will make the compressor operate continuously,
lowering the cabinet temperature still further than the thermostat setting.
•
This switch is used to freeze unfrozen food in appreciable quantities.
•' When loading the freezer, freeze only three pounds of fresh food per cubic foot of
freezer space at one time.
•
Distribute packages to be frozen evenly throughout the freezer.
10
Publicidad
