Front Panel; Rear Panel - Power Dynamics PDC09 Manual De Instrucciones

Turn this knob to control the mix of headphone out between the CUE mix and PGM (master output) mix.
23. Master
Adjust the overall volume.
24. Headphone level
Adjust the headphone volume.
25. PC/line selector
Switches the corresponding DECK between MIDI and analog mode
PC mode (green LED off): the audio signal coming via the USB connection serves as signal source.
Line mode (green LED lights): the analog line/phono input serves as signal source.
26. Channel level
Adjust the channel volume.
27. Crossfader
For crossfading between Deck A and Deck B. In mid-position both decks can be heard at the same volume.
FRONTPANEL
28. Headphone inputs
6.3mm and 3.5mm jacks for connecting stereo headphones.
29. X-fader curve
Adjust the characteristic of the crossfader:
- Left position: smooth crossfading (gradual transition) for long mixes.
- Right position: sharp crossfading (abrupt transition) for scratching and cutting.
30. Microphone level
Volume control for DJ microphones connected to the jacks MIC1 and MIC2.
31. Microphone inputs mic1/2
Input jacks for connecting DJ microphones via XLR or 6.3mm (1/4") jack.

REAR PANEL

32. Ground terminal
Ground clamping screws for turntables with separate ground lead.
33. Analog input line/phono
Stereo inputs (RCA) for Deck A and Deck B for connecting analog units with line level outputs or turntables with
magnetic system.
34. Input selector switch line/phono
Switch the analog inputs between phono and line input.
35. Recording output REC
Stereo output (RCA) of the master signal for connecting and amplifier or other units with line level inputs.
36. Master output
Unbalanced stereo output (RCA) of the master signal for connecting an amplifier or other units with line level inputs.
37. Booth output
Stereo output (RCA) for connecting a further amplifier for the monitoring system or PA application in a secondary room.
38. Power input
For connecting the 5V/1A adaptor.
39. Power select switch
Position Adaptor: power supply is via the 5V/1A adaptor
Position OFF: controller is powered off
Position USB: power supply is via the USB connection
40. USB Port
USB jack type B for connecting computer.
41. Balanced master output
Balanced stereo output (XLR) of the master signal for connecting and amplifier or other units with line level inputs.
5