cecotec ENERGYSILENCE 3500 COOL COMPACT SMART Manual De Instrucciones página 33

2. Before using the appliance, make sure that both the air inlet and outlet are free of
obstructions and not blocked.
3. Plug the appliance into a power supply.
Filling up the water tank
1. First, make sure the rubber plug, which is located at the back of the cooler, is properly
inserted into the water outlet. Otherwise, water could leak out.
2. Fill the water tank (located on the top of the cooler or see figure 1). Open the tank lid and fill
the water tank with clean water. Make sure to respect the following marks:
- "MIN" mark
The water level in the tank must be above the "MIN" mark for the pump to operate correctly.
- "MAX" mark
The water level in the tank must not exceed the "MAX" mark, otherwise water may enter
the appliance and damage the electronic parts.
3. Make sure the water tank is not damp or wet on the outside. If it is, wipe it dry with a cloth.
4. Close the lid again.
Control panel
Fig. 3
1. Power icon
Press the power icon
2. Speed icon
Press the speed icon
- F1- Low speed
- F2- Medium speed
- F3- High speed
The cooler will start operating at the selected speed when the display stops flashing.
3. Timer icon
Use this icon to switch the appliance off at a set time. Each time you press the
operating time is extended by 1 hour.
NOTE: the minimum time that can be selected is 1 hour and the maximum time is 12 hours.
To switch the cooler off automatically, follow the steps below:
- While the cooler is in operation, press the timer icon
duration is lit.
- The setting is saved when the light of the desired duration stops flashing.
- Once the selected time has elapsed, the cooler will switch off automatically.
to switch on/off the cooler.
. The display will show the following:
repeatedly until the desired
ENERGYSILENCE 3500 COOL COMPACT SMART
ENGLISH
icon, the
33