cecotec ENERGYSILENCE 3500 COOL COMPACT SMART Manual De Instrucciones página 35

To change the batteries in the remote control, follow the instructions below:
1. Open the remote-control cover on the back.
2. Remove the used battery carefully, paying attention to its orientation and polarity.
3. Insert the new AAA battery, making sure to insert it in the correct direction.
4. Close the cover by pressing gently until it clicks into place.
5. Test the remote control to make sure that it works properly with the new battery.
Cold packs
Fig. 5
Together with the cooler, you will receive two cold packs that you can place on top of the
appliance to make the air even cooler.
When using them, please note the following:
- Fill them up to the "MAX" mark.
- Before use, put them in the freezer for 3-4 hours.
- Fill the tank with water, making sure not to exceed the "MAX" mark.
- Put the cold packs in the compartment at the top of the cooler.
Tips for use
- Protect the room where the appliance is located from direct sunlight with curtains, blinds
or shutters. This will allow you to save energy.
- Do not place objects on top of the appliance or obstruct the air outlet.
- Keep the air inlet and outlet grilles clear.
- Make sure that there are no heat sources operating in the same room.
- Never use the appliance in very damp rooms (e.g. laundry rooms).
- Do not use the cooler outdoors.
- Make sure that the appliance is on a level floor.
4. CLEANING AND MAINTENANCE
Cleaning the grille
To ensure efficient operation of the cooler and correct air flow, you should clean the inlet and
outlet grille every week (if you have been using the appliance).
1. Before cleaning the cooler, switch it off. Wait a few minutes and unplug it from the mains.
2. Use a screwdriver to remove the 2 locking screws from the rear grille. When you have done
so, remove the grille.
ENERGYSILENCE 3500 COOL COMPACT SMART
ENGLISH
35