NISBETS ESSENTIALS DN987 Manual De Instrucciones página 5

Blending
Before use, ensure to
• Clean all removable parts thoroughly.
• Turn off On/Off switch (OFF position).
1. Plug in Blender.
2. Place ingredients into blender.
3. Secure the lid and lid plug (Note: Always operate
with the lid secured).
4. Locate jug on the body of blender.
5. Select speed using variable speed dial.
6. Turn on blender using On/Off switch.
7. Using the pulse function: Set the Pulse switch
to ON position and hold to start pulse function.
Release to stop.
The appliance is to use with liquids or semi-liquid
mixtures. To avoid overheating or damage, do not
let it run at the MAX speed continuously for more
than 2 minutes.
Note: When blending hard ingredients best
results will be obtained by cutting ingredients
into small pieces and adding to the blender
through the hole in the lid when motor is running.
Note: Before removing jug, ensure to turn off
blender using On/Off switch and let the motor
come to a complete stop.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Jug incorrectly located on body of
appliance
Unit stops working Motor overheating protection is
suddenly activated
DN987_ML_A5_v1_20231122.indb 5
Cleaning, Care &
Maintenance
•
•
•
•
•
•
Warning: Blade is sharp! Be careful when
emptying the jar and during cleaning.
Warning: Do not allow any water to spill into the
body of the appliance when cleaning.
Warning: Never attempt to remove the blade
assembly from the jar for cleaning as its removal
requires special tools and can only be carried out
by our service personnel.
Cleaning the jug and blade assembly
•
•
•
Probable Cause
Always disconnect from power supply before
cleaning.
Always allow to cool before cleaning.
Let the motor come to a complete stop before
removing the jug.
The jug is NOT dishwasher proof!
Use warm, soapy water and a damp cloth to clean
the jug.
Dry thoroughly after cleaning.
Add water and mild detergent into the jug, then
locate the lid and lid plug.
Secure the jug on the body and switch on at MAX
speed for 10-20 seconds.
Switch off and remove the jug, then rinse with
clean water thoroughly. Ensure no water will get
contact with the underside of the jug.
Solution
Check unit is plugged in correctly and switched
on
Replace plug or lead
Replace the fuse
Check mains power supply
Relocate Jug
Switch off and unplug. Wait to let the motor to
cool sufficiently, then restart
EN
5
2023/11/22 13:58:26