Publicidad
Idiomas disponibles
Idiomas disponibles
Bri_s
& Stratton Power Products Automatic
Transfer Switch
Installation
and Owner's
Manual
INTRODUCTION
Thank
you for your purchase of this Briggs & Stratton
Power Products Automatic
Transfer Switch.This
product is
intended for use with Briggs & Stratton
Home Standby
Generator
sets ONLY.This
is an optional home standby
system which provides an alternate source of electric
power and to serve loads such as heating, refrigeration
systems, and communication
systems that, when stopped
during any power outage, could cause discomfort,
or the
like.This product DOES NOT qualify for emergency
standby as defined by NFPA 70 (NEC).
Briggs and Stratton Power Products (BSPP) has made every
effort to provide for a safe, streamlined
and cost-effective
installation. Each installation
is unique; it is impossible for
BSPP to know and advise of all conceivable
procedures and
methods by which installation might be performed,
nor the
potential
hazards associated with those methods. For these
reasons,
Only
licensed
electrical
contractors
should
install
transfer
switches.
Installations
must
strictly
comply
with
all applicable
federal,
state
and local codes, standards
and
regulations.
Your BSPPTransfer Switch is supplied with this combined
"Installation
and Owner's
Manuar'.This
is an important
document
and should be retained by the owner after the
installation has been completed.
Every effort has been expended to make sure that the
information
in this manual is both accurate and current.
However, the manufacturer
reserves the right to change,
alter or otherwise
improve the system at any time without
prior notice.
For the Home
or Business Owner
To help you make informed choices and communicate
effectively with your installation
contractor(s),
Read
and
understand
the
Owner
Orientation
Section
of this manual
BEFORE
contracting
or starting
your
transfer
switch
installation.
To arrange for proper installation, contact the store at
which you purchased your BSPPTransfer Switch, your
dealer, or your utility power provider.
The Transfer
Switch Warranty
is VOID
unless the system
is installed
by a
licensed
electrical
professional.
For the Installing
Dealer/Contractor
Check federal, state and local codes for questions on
installation.
If you need more information about the transfer switch,
call 1-800-743-4115,between 8:00 AM and 5:00 PM CT.
Owner
Orientation
The illustrations
are for typical circumstances
and are
meant to familiarize you with the installation options
available with your transfer switch.
Local codes, appearance, and distances are the factors that
must be considered when negotiating with an installation
professional.As
the distance from the existing electrical
service increases, compensation
in wiring materials must be
allowed for.This is necessary to comply with local codes
and overcome electrical
voltage drops.
The factors
mentioned
above will have a direct effect
on the overall price of your transfer switch installation.
NOTE:
Your installer must check local codes AND obtain
permits before installing the system.
• Read and follow the instructions
given in this manual.
• Follow a regular schedule in caring for and using your
transfer switch, as specified in the manual.
Installer
Responsibilities
• Read and observe the safety rules.
• Read and follow the instructions
given in this manual.
• Check federal, state and local codes.
Publicidad
