MANUAL
a
/
=z
ea
Qaneen eT
a
s
DISPLAY
een
3. Press one of the buttons of SEA CONTROL.
The range you have selected from between 63Hz (low) to 16kHz (high) will start blinking.
Q
Ifyou press the SEA CONTROL button without first pressing the FLAT button, the range
for the pattern which is currently being called up will start blinking and the MANUAL
S.E.A. mode will be automatically set.
4. Using the SEA CONTROL button, you can now create your own frequency patterns.
: To increase the level of the frequency range which is blinking.
(J : To decrease the level of the frequency range which is blinking.
C)
. CJ: To select a frequency range.
{
Evey time you press the (=) or
button, the frequency range will change in the
following order.
=
+ 63Hz <> 160Hz <> 400Hz «> 1kHz «> 2.5kHz «> 6.3kKHz «> 16kKHz <>
«- C)
5. Storing frequency patterns you have created with POPS/A ~ CAR/F.
Press the MEMORY button. "MEMORY" will light up on the Display and the frequency
pattern by you will blink for a few seconds. (If the pattern stops blinking and lights up instead,
press the MEMORY button again.)
While the frequency pattern is blinking, press the
or
SEA PRESET button to
select from POPS/A
~ CAR'SF to store it with.
Press the MEMORY button again to memorize.
NN
— ——_—EEEreee
Calling up a pattern you have created using the
Manual S.E.A. mode
Preset patterns you have created and put into memory can be called up easily.
1. Press the SEA ON/OFF button to turn on the S.E.A. function.
The indicator will light up.
2. Press the MANUAL button of the SEA PRESET button to select the Manual S.E.A. mode.
"MANUAL" will light up on the Display.
3. Call up the pattern by selecting from POPS/A ~ CAR/F using the SEA PRESET
or
button.
ee
Changing the S.E.A. Display
The Display mode has 2 types — PEAK HOLD and EQUALIZING PATTERN. Pressing the
DISPLAY button will alternate the type.
PEAK HOLD
PROGRAMMED
J
00
tk
25k
6%
16kHz
TOTAL
CARF
8
160
400
tk.
25k
6%
6kHz
TOTAL
~<J
400
tk
25k
63k
16kHz
TOTAL
63
160
400
tk
2.5k
6.2%
= 16kHz
TOTAL