Create Wind Clear Rattan Manual De Instrucciones página 10

IN STALLIN G THE MOUNT I NG B R ACKE T
Before installing the mounting bracket you should check the ceiling where the fan is to be
installed and check if it is suitable for it.
Concrete ceiling
Drill 2 holes with an 8mm drill bit, accord-
ing to the length of the expansion bolts.
Next, fix the mounting bracket to the ceil-
ing with the screws.
Do not fix the mounting bracket directly on ceilings less than 10mm to avoid the risk of the
screw loosening and coming out.
NOTE: This fan can also be installed in a false ceiling, for this you must use fixing screws
with a spring lever (not included).
D OW NROD I N STALL AT I O N
• Choose the suspension bar that best suits your situation.
• Remove the bar bolt, removing the pin, and pass the canopy (roof trim) and the engine
canopy through the suspension bar. Next, route the fan motor cables through the in-
side of the suspension bar. Tighten the suspension bar to the engine and insert the
bolt and pin.
Standard mounting
Standard mounting hangs from the ceiling
by a downrod.
This fan can be installed on both a regular and vaulted ceiling, and can extend the hanging
length with the longer hanging rod (supplied). To install the hanger bar you will need the
following tools: a screwdriver, flat head screwdriver, adjustable pliers or wrench, step ladder,
wire cutters, and electrical tape.
E NGL I SH
10
Wood roof
Attach the mounting bracket to the wood
ceiling with 4 minimum 7mm thick screws.
Angle mounting
Angled mounting recommended for a vault-
ed or angled ceiling.