Polar UA044 Manual De Instrucciones página 4

EN
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your POLAR product.
This appliance is intended for making drinks and
cold beverages. If used with dairy-based products
and/or when envisaged by law in accordance to
the type of product used, it must be equipped
with the optional extra of a temperature gauge
for the product in the bowl. It is also obligatory to
comply with the current regulations and standards
concerning the products used.
Note: Only two types of persons can access
the appliance:
• User: A person who has adequate technical
training on how to use the appliance correctly,
and full knowledge of routine work on how to
maintain, clean and sanitize the appliance.
• Specialized technician: A person who has
the full knowledge of the appliance concerning
the installation, use and servicing of the
appliance.
Pack Contents
The following is included:
• Polar slush maker
• Drip Tray:
UA044 x 1/UA045 x 2/UA046 x 3
• Seal of auger:
UA044 x 1/UA045 x 2/UA046 x 3
• Seal of bowl:
UA044 x 1/UA045 x 2/UA046 x 3
• Filter x 1
• Vaseline (for lubrication of the appliance)
• Instruction Manual
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
4
UA044_UA045_UA046_ML_A5_v1_20240112.indb 4 UA044_UA045_UA046_ML_A5_v1_20240112.indb 4
Installation
Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 25cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Before installation, ensure to
check that:
• The appliance is installed indoors.
• The room is adequately lit, well-
ventilated and hygienic.
• The location of the appliance is flat and
solid, and can support its weight.
• The appliance may only operate in
places with an ambient temperature
ranging between 16°C and 32°C.
• Adequate clearance is kept around
the appliance to enable personnel to
operate without constraints.
Installing the drip tray
Mount the drip tray in place on the front.
2024/1/12 10:10 2024/1/12 10:10