Publicidad
Idiomas disponibles
Idiomas disponibles
After completing the installation work, check to make sure that there is no refrigerant
leakage.
Never directly touch any leaking refrigerant and the refrigerant pipes.
It could cause severe frostbite. During and immediately after operation as the refrigerant pipes
may be hot or cold, depending on the condition of the refrigerant flowing through the
refrigerant piping, compressor and other refrigerant cycle parts. Burns or frostbite are possible
if you touch the refrigerant pipes. To avoid injury, give the pipes time to return to normal
temperature or, if you must touch them, be sure to wear protective gloves.
Do not touch the internal parts (pump, backup heater, etc.) during and immediately
after operation.
Touching the internal parts can cause burns. To avoid injury, give the internal parts time to return
to normal temperature or, if you must touch them, be sure to wear protective gloves.
Do not place heaters or other electrical appliances near the power cord (It may
cause fire or electric shock)
Please note that water cannot be poured directly from the unit. Do not let water
enter electrical components. (It may cause fire or electric shock)
If the unit is not used for a long time, it is recommended not to turn off the power
supply. If the power is turned off, the protection devices of some products (such as
water pump anti lock and anti freezing device) will not be available.
Cautions
Please carry out drainage system and the pipeline work according to the
instructions.
If the drainage system or pipeline is defective, water leakage may occur, and it should be dealt
with immediately to avoid getting other household products wet and damaged.
Install the power wire at least 3 feet (1 meter) away from televisions or radios to
prevent interference or noise. (Depending on the radio waves, a distance of 3 feet
(1 meter) may not be sufficient to eliminate the noise.)
Please do not clean the unit when the power is on. When cleaning the unit, please
turn off the power after shutting down. Otherwise, you may be injured by a high-
speed fan or electric shock.
Do not use means to accelerate the defrosting process or to clean, other than
those recommended by the manufacturer.
Do not wash the unit. This may cause electric shocks or fire.
Do not install the unit in the following places:
- Where there is mist of mineral oil, oil spray or vapors. Plastic parts may deteriorate, and
cause them to come loose or water to leak.
- Where corrosive gases (such as sulfurous acid gas) are produced. Where corrosion of
copper pipes or soldered parts may cause refrigerant to leak.
- Where there is machinery which emits electromagnetic waves. Electromagnetic waves can
disturb the control system and cause equipment malfunction.
- Where flammable gases may leak, where carbon fiber or ignitable dust is suspended in the
air or where volatile flammables such as paint thinner or gasoline are handled. These types of
gases might cause a fire.
3
Publicidad
