Steren COM-598 Manual De Instrucciones página 37

CONFIGURATION OF SCAN MODES
ATTENTION
DO NOT scan the codes in this manual just to test the reader. In case of an error, scan the
following codes to return the reader to the factory settings. The reader will emit a tone.
Serial Mode
Initial setup
Normal Mode: Scan this code so that the reader sends the information in real time,
immediately.
Inventory Mode: Scan this code for the reader to save the information. Then scan the
"Upload information" code to send the information to the computer.
If you scan the code "Total number of data" the computer will show how many codes have
been read in Inventory Mode.
Scan the "Clear Data" code to clear code memory read during Inventory Mode.
Normal mode
Inventory Mode
Non-Volatile Mode
Upload Data
Total number of data
Clear data (be careful)
6