Publicidad
Idiomas disponibles
Idiomas disponibles
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Press the red button to turn the device on, press again to turn in standby mode.
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode, press
To change the colour of the strobe, press
To put the UV light on press
To turn on Sound-Active mode, press
To turn on the red or green laser on, press
To change the strobe with LEDs, press
To change the derby effect.
1. Press
on the remote controller.
2. Press
or
to change effect.
To change the speed of colour change, colour fade, sound active and strobe modes.
1. Press
on the remote controller.
2. Press
or
to increase or decrease the speed of colour change.
To adjust sound sensitivity for in Sound-Active mode
1. Press
on the remote controller.
2. Press
or
to either increase or decrease sound sensitivity(note: only available in sound active mode).
on the remote controller.
.
, to put the UV light off press
on the remote controller.
.
.
once again.
Publicidad
