Buffalo CU614 Manual De Instrucciones página 5

Connecting the basket handle
Care must be taken to ensure that the handle
is correctly located, and securely pulled back
in to position before being used.
1. Squeeze the two ends of the handle
together.
2. Slot the ends of the handle in to the
basket.
3. Lower the handle so that it slots over the
frame of the basket.
Start frying
1. Pour cooking oil into the oil tank between the MIN and MAX markings.
2. Connect the appliance to the mains power supply.
3. Set the POWER switch to I (ON position).
4. Set the thermostat to the desired temperature (50°C-190°C). The HEAT indicator light turns On,
indicating the appliance begins to heat the oil.
Note: 170°C to 180°C is suitable for general cooking.
5. When the set temperature is reached, the HEAT indicator light turns Off.
6. Lower the basket with food into the oil. The HEAT indicator light turns On again.
Note: During use, the HEAT indicator light will cycle on/off, indicating the set temperature
is being maintained.
7. When the food is cooked, lift the basket and hang it onto the oil tank's support. Allow the oil to drain
from the frying basket for seconds.
WARNING: The food and oil are very hot! Take care when removing the basket as oil may
drip.
8. After use, set the POWER switch to O (OFF position) and disconnect the appliance from power supply.
Overheat protection
This appliance is featured with an overheat protection. Should the temperature exceed safe levels the
appliance will automatically cut off power.
The thermal Cut-out switch is located on the rear of the appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks, using a blunt pointed instrument.
3. The appliance is now reset and can be used as normal.
Cleaning, Care & Maintenance
• Always turn Off the appliance and disconnect from the power supply before cleaning.
• Always allow the oil to cool before cleaning, ideally for at least 6 hours.
• Check the temperature with a suitable probe thermometer; 40ºC is the MAXIMUM temperature at
which oil should be removed.
• For best performance, Buffalo recommend that the appliance is cleaned after each day of operation.
CU614-CU615-CU616-CU618_ML_A5_v1_20240207.indb 5
EN
5
2024/2/7 14:35:03