Xblitz Night 2 Manual Del Usuario página 13

PURPOSE OF THE PRODUCT
The Xblitz Night 2 dash cam with night mode and Wi-Fi allows you to
monitor your vehicle's route and record any traffic incidents. The camera is
created from the highest quality components.
BEFORE USE
1. It is recommended to use original micro SD cards of class 10 or higher.
2. Before placing the memory card in the recorder, it must be formatted
on the computer in the FAT32 or exFAT file system (depending on the
card) and then in the recorder.
3. The memory card must be installed when the device is switched
off. Failure to do so may damage the card and the device. The same
applies when removing the card from the device.
4. Set in the menu:
a. Date and time.
b. Loop recording (adjust recording time). If you disable loop recor-
ding, the files will not be overwritten.
c. Set the highest resolution available.
d. Set the G-Sensor to the lowest possible sensitivity so that the
camera does not catch bumps in the road and secure unnecessary
recordings.
e. Enable WDR mode.
5. When the memory card fills up, the oldest unprotected recordings
are overwritten.
6. The camera will start recording automatically every time you switch
it on (provided there is no permanent power supply in your car's
cigarette lighter socket).
7. It is recommended to use the functions of the device according to
their intended use, that is, not to use the PARKING MODE and MOVE-
MENT DETECTION functions while driving. This may cause recording
to start and stop automatically and unnecessary loss of space on the
memory card.
8. Sound: the device has a condenser microphone that records all
ambient sounds. Sounds may overlap causing distortion.
01. CONTENTS OF THE KIT
1. Dash cam
2. Charger
3. Handle
4. Electrostatic foil
5. Micro SD memory card reader
13