Oster GCSTBS-100 Manual De Instrucciones página 18

SETTING UP AND USING THE DOOR PRESS PAD
Setting Up
1. Verify that you have all the parts necessary for the
setup (see illustration under LEARNING ABOUT
YOUR STEAMER).
2. Attach the 2 support rods together then insert the
combined rod into the top opening of the press
pad (Figure 4).
3. With the door completely open, position one strap
loop over each corner of any door, making sure
the white terry cloth side with the Oster logo is
facing toward you.
4. Loop each strap around each corner on the door (Figure 5).
Tip: You can pull on the straps through the fasteners to adjust their
lengths to fit the door.
Notice: Steam can get through and around the press pad. Do not
use on doors that are sensitive to heat or moisture.
5. Once the strap loops fit and the press pad is at a comfortable
height, gently pull down on it to ensure it is secure. Close the
door completely to help keep the press pad secured in place for
pressing.
Using Your Press Pad
1. If the press pad is set up, hang your garment to be steamed on a clean, rust-free
hanger and insert the hanger in the center loop at the top of the press pad. If it is not
set up, refer to the instructions in Setting Up section, above. Use any of the two side
loops on the press pad to hang your clothes when steaming sleeves.
2. Follow steps 1-13 under STEAMING VERTICALLY.
STEAMING HORIZONTALLY
You can also use your Steamer as an iron to refresh sheets, pillows, mattress, sofas and
more.
1. After the water tank is filled, make sure there is no residual water inside the
center water tank cavity. Attach the water tank to the steamer. Attach the desired
accessory to the steamer and follow steps 3 and 4 under USING YOUR STEAMER
VERTICALLY.
2. Once the Steamer has reached set temperature, press trigger switch and in a
horizontal position, move the steamer continuously over the fabric being steamed.
Caution: The heated press bar gets hot, do not touch.
3. Once you finish, slide switch to Off and unplug unit. Wait for unit to cool completely
before emptying the water tank or removing accessory.
• I mproper use of the Steamer can cause property damage due to the steam. Always
read the instructions in this manual before using your Steamer.
• D o not operate the Steamer with an empty water tank. To add water during
operation, turn steamer off, wait for it to cool down then remove water tank and refill.
• A lways read the fabric care labels to help determine fabric type to be steamed. If
unsure of fabric's fiber, test a small hidden area, such as an inside seam or hem,
before steaming.
English - 7
Figura 4
Door
Puerta
Figura 5
Do
Pue