Care And Cleaning - Oster GCSTBS-100 Manual De Instrucciones

Vaporizador portátil
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• F or more difficult wrinkles, try steaming from the underside of the fabric.
• U se caution when hanging clothing on the Over the Door Press Pad. Too much
weight or pulling on the garment may cause the press pad to slip from the door and
fall down.
• W hen steaming, touching fabric lightly with the steam nozzle can help in wrinkle
removal. It is important to make contact with the garment and/or fabric.
• H eavier fabrics require more steam.
• O nly use water in the unit. Do not add cleaning solutions, scented perfumes, oils or
any other chemicals to the water that can cause damage to the appliance.
• D o not use steam against wall or doors.
• W hen hanging garment on a door while steaming, be careful not to damage the
door with steam. Use the Over the Door Press Pad to protect your door.
• A fter use, empty water tank by turning it upside down to ensure all water empties
out and avoid leaks.
• W hen steaming, move the steamer continuously over the item being pressed. Do
not keep steamer over an area for any period of time to avoid damage to the fabric.
CLEANING
1. Make sure unit is off, unplugged and allow it to cool completely before cleaning.
2. If there is water in the water tank, remove the tank and turn it upside down to ensure
all the water empties out.
3. Wipe exterior surfaces with a soft, damp cloth. Dry thoroughly.
Warning: Never immerse steamer, cord or plug in water or any other liquid.
• D o not use abrasive cleaners or scouring pads that can scratch the surface.
• Do not place in the dishwasher.
4. Remove press pad from the door to disassemble:
a. G rip one end of the support rods and slide out.
b. P lace press pad in the washer and wash in cold water and laundry detergent then
air dry.
c. O nce dry, reassemble the press pad as instructed under SETTING UP AND USING
YOUR OVER THE DOOR PRESS PAD.
CLEANING WITH VINEGAR AND WATER
It is recommended to clean your Steamer every two months to reduce mineral buildup
that can affect the performance of your unit.
1. Turn off the unit and let it cool completely.
2. Remove water tank and make sure it is empty.
3. Fill water tank with a solution of 50% white vinegar and 50% water up to the max
level.
4. Plug unit into electrical outlet and press trigger to run a full steaming cycle.
5. Once steaming is finished, fill with clean water and repeat process until the vinegar
odor is eliminated.

Care And Cleaning

English - 8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gcstbs-200

Tabla de contenido