HITWAY BK8 Manual página 17

9. Install the Bell
Using the Phillips screwdriver in the 16-in-1
tool, loosen the screws on the bell bracket.
10. Power-on Show
1. Insert the key into the key hole at "1" in
the picture, and turn the key to the "ON"
position by turning the key to the right at
the "OFF" position.
2. Press the switch at "2" in the picture to
power on the display. Otherwise, power
off.
Put the bell bracket into the corresponding
position of the handlebar, and tighten the screw
with a Phillips screwdriver.
-14-
2
1