HITWAY BK8 Manual página 8

5
5. Use the assembled tool
to tighten the nut.
3. Install the Front Wheel
1. Loosen the nut shown in the
picture with the No. 15 open-end
wrench in the 16-in-1 tool and
remove the support shaft.
6
6. Use the No. 4 Allen key in the
16-in-1 tool to remove the fixing
screws of the mud plate support
rods pre-installed on the left
and right sides of the front fork.
-5-
7
7. Fix the front fender support to
the corresponding screw holes
of the front fork and use the No.
4 Allen key in the 16-in-1 tool to
tighten the screws.
1