Publicidad
Idiomas disponibles
Idiomas disponibles
Mixing ratios:
When using 2-cycle oil (FC grade)
25:1 (160 ml of oil for every 4 liters of gasoline)
CHAIN OIL
Use motor oil SAE#100W-30 all year round or SAE#30~#40
in summer and SAE #20 in winter.
NOTE: Do not use wasted or regenerated oil that can cause damage to the oil pump.
7. OPERATING ENGINE
WARNING! It is very dangerous to run a chainsaw that mounts broken parts or lacks any parts.
Before starting the engine, make sure that all the parts including bar and chain are installed properly.
STARTING ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten the caps securely. (F7)
2. Flip the switch to "I" position. (F8)
3. Pull out the choke knob to the closed position. (F9)
(1) Chain oil.
(2) Fuel.
(3) Switch.
(4) Choke knob.
NOTE: When restarting immediately aﬞer stopping the engine, leave the choke knob in the open
position.
4. While holding the saw unit securely on the ground, pull the starter rope vigorously. (F10)
WARNING! Do not start the engine while hanging the chainsaw with a hand. The saw chain may touch
your body. It is very dangerous.
5. When the engine has ignited, first pull the throמּle lever slightly to return the choke knob to the open
position and then pull the starter again to start the engine.
F7
(1)
(2)
F8
(3)
F9
(4)
F10
11
Publicidad
