compliance could void the user's authority to operate the equipment.
SAVE THESE INSTRUCTIONS
Legal
Manufacturer shall not in any way be liable to you or to any third party for any damages
you or any third party may suffer as a result of use, intended or unintended, or misuse
of this product in conjunction with any device or accessory other than the appropriate
device for which this product is designed. Manufacturer will not be responsible for
any damages you or any third party may suffer as a result of misuse of this product
as outlined above. Purchaser agrees to defend, indemnify, and hold Manufacturer
harmless for any claims or damages arising from unintended use or misuse, including
use with an unintended device.
This device complies with part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation
is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced technician for help.
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15
of the FCC Rules, this device must be used with certified peripherals and shielded
cables. All peripherals must be shielded and grounded. Operation with non-certified
peripherals or non-shielded cables may result in interference to radio or reception.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
MODIFICATION: Any changes or modifications of this device could void the warranty.
STATEMENT OF COMPLIANCE:
Hereby, ZAGG International declares that the radio equipment wireless charging
device is in compliance with Directive 2014/53/EU. The full text of the EU declaration
of conformity is available at the following Internet address: http://www.mophie.com/
cert_red.
WEEE STATEMENT: All of our products are marked with the WEEE symbol; this
indicates that this product must NOT be disposed of with other waste. Instead it
is the user's responsibility to dispose of their waste electrical and electronic
equipment by handing it over to an approved re-processor, or by returning it to
mophie, inc. for reprocessing. For more information about where you can send your
waste equipment for recycling, please contact mophie, inc. or one of your local
distributors.
6