Lubrication; Blades - VOSS.farming easyCUT go Instrucciones De Uso

• Store the battery module at a sufficient distance from other metal objects (e.g. nails,
screws).
• Protect the battery module from moisture and humidity.
• A short circuit would result in overheating, burning, or breakdown.
• Do not burn the battery module even if it is inoperative. It may still explode in fire.
• Do not drop the battery or otherwise subject it to shock or impact.
• During charging, the battery must be in a well-ventilated room, never in a crate, box or
similar. The ventilation opening of the charger should always be free.
Please only use special clipping machine oil for this purpose.
tighten
at most and start clipping. If the result is not satisfactory, adjust the tension between the
blades slightly. If the following result is still not good, your blades are probably dull.
18

3. LUBRICATION

Lubrication is essential for a good result.
It also prevents overheating and signifi-
cantly prolongs the life of the machine and
the blades. For this purpose, a thin film of
oil must always be present on the moving
parts of the head.
Drip the oil every 10 minutes onto the bla-
des and into the opening as shown in the
pictures. Make sure that both elements do
not run dry under any circumstances.

4. BLADES

Caution: Before making any adjustments
loosen
to the blades, make sure that your machi-
ne is switched off and disconnected from
the power supply. Always separate the
battery from the clipper.
4a. Adjusting the blades correctly
Before clipping: Adjust the tension nut
(see picture) while the clipper is switched
off. Turn the nut until first resistance is
felt. Afterwards, rotate another ¼ of a turn