Operating instructions - English
1.
Notes on these operating instructions
1.1 Content and target
group of the
instructions
1.2 Obligations of the
operator
1.3 Personnel
qualifications
1.4 Exclusion of liability
10
These operating instructions apply to the Dialock Furniture Terminal, called „FT 120" in the
following.
It is essential to pay attention to these operating instructions in order to operate the product
successfully and safely. Please pay attention to all of the specified instructions and notes!
The operating instructions consist of two separate documents:
•
Operating instructions
•
Installation instructions
The following parts of the instructions must be read and observed by the specified groups of people
before they start to use the product:
Group of people
Operator
Installation and
start-up personnel
Operating personnel
The operator has the following obligations:
•
The operating instructions and the installation instructions must always be ready to hand
for the specified groups of people.
•
Users of the locking system who do not have access to the operating instructions must be
instructed by the operator how to use the product properly.
•
The instructions must be kept until the product is disposed of, and handed to the new
operator in the event of a change of operator.
•
Any abuse of the keys must be prevented.
•
The programming and clearing keys must be kept in a safe place, since unauthorised
persons can gain locking authorisations to furniture with both keys.
Installation and start-up personnel
Installation and initial start-up may only be carried out by trained experts. Knowledge of the
following is a prerequisite:
•
National accident prevention regulations.
•
Safety regulations for the use of electricity.
If the installation and start-up personnel do not have these qualifications, a specialist installation
company must be commissioned to do the work.
Persons who are under the influence of drugs, alcohol or medicines that affect reactions must
not install or start up the equipment.
Personnel who are being trained may only install and start up the product under supervision or
after being authorised to do so by someone with experience.
The operator and the installer are personally responsible for compliance with the VDE
regulations (or the national electrotechnical and electronics regulations).
Operating personnel (personnel with locking authorisations)
The operating personnel must be informed about the following:
•
Safe and proper handling of the product.
•
Responsible use of locking authorisations.
Service and maintenance personnel
Cleaning work on the product may be carried out by the operating personnel (after
obtaining authorisation from the operator). Other maintenance work is not permitted.
No liability is accepted for injuries or damage which are attributable to one or more of the
following reasons:
•
Failure to read and/or follow the instructions.
•
Abuse of the equipment.
•
Inadequately qualified / instructed personnel.
•
Failure to use original spare parts.
•
Negligent handling of the product.
Part of instructions to be read
Entire operating instructions
Entire installation instructions
Entire operating instructions
Entire installation instructions
Chapters 6 - 8 of the operating instructions
The operator must insruct the operating personnel how to
operate the product safely and properly.