Initial Start-Up; Allocating Locking Authorisations - hafele Dialock FT 120 Instrucciones De Funcionamiento

4. Installation
5. Start-up

5.1 Initial start-up

6.

Allocating locking authorisations

6.1 Keyed alike operation
The installation instructions are a separate document and are enclosed with the product.
They are exclusively intended for:
• The operator,
• The installation and start-up personnel.
WARNING
Life-threatening electric shock during the installation with a plugged in mains plug!
The entire installation process must occur without power!
> Never connect the mains plug to the socket during the installation process.
> Even after completing the installation process, do not connect the mains plug.
The "initial start-up" is thereby immediately started.
> Prior to connecting the mains plug for the first time, first read chapter
"Initial Start-Up" of the operating instructions.
The product is supplied in so-called simple mode for stand-alone operation (SA). These
instructions only describe how to start up in this mode.
Details on the use of the product with software applications can be found in the relevant
software documentation.
Configuration / reading out audit trails with the MDU
This description is in a separate document „Configuration of the FT 120 and administration of
the keys with Dialock SERVICE software".
The initial start-up is only possible once after connecting the mains plug to the socket for the
first time. The individual instruction steps must be carried out within a short time window. Therefore:
• Study every instruction step and have the keys that are needed available before commencing
with initial start-up.
• Perform the instruction steps quickly and without interruptions.
For step-by-step instructions „Start-up - Allocating programming and clearing
keys" see illustrations on page 44 ff.
NOTE
Warning of abuse!
Unauthorised persons obtain locking authorisations with programming and clearing keys.
> Only personnel who are authorised by the operator may allocate locking authorisations!
> Take care when allocating locking authorisations to avoid overlapping or mistakes.
> Keep programming and clearing keys in a safe place and protect from abuse.
Up to 16 MLA 8s can be switched in sequence in this operating mode, i.e. up to a maximum of
128 outputs can be controlled.
For step-by-step instructions „Allocating locking authorisations - keyed alike"
see illustrations starting on page 45.
13